Garage Floors & Flatwork in Summertown & Southern Middle Tennessee

Garage floors and general flatwork — shop floors, utility pads, equipment slabs — need to be flat, strong, and resistant to the chemicals and impacts they'll face daily. A residential garage floor carries vehicles weighing 4,000 to 8,000 pounds rolling across it every day, handles hot tire contact in summer, and endures road salt and moisture tracked in during winter. It has to be built for that kind of use.

We pour garage floors at a minimum of 4 inches thick, with 5–6 inches recommended for shops and buildings that will see heavier equipment. The concrete mix includes air entrainment for freeze-thaw resistance and we specify a minimum 4,000 PSI mix for garage applications. Reinforcement is fiber mesh or welded wire, with rebar in thickened edges and at any penetrations or transitions.

Flatness matters in a garage or shop. We use laser-guided screeding where possible and hand-check with straightedges to ensure the floor is consistently flat. A floor that dips or humps creates problems — water pools in low spots, equipment doesn't sit level, and vehicle lifts require shimming. We also maintain a consistent slope toward the garage door (about 1/8 inch per foot) so water drains out rather than collecting inside.

Surface finish on a garage floor is typically a steel trowel or light broom. Trowel finish gives a smoother, easier-to-clean surface but can be slick when wet. Broom finish provides more traction. For shops and commercial garages, we can also apply a hardener to the surface during finishing that increases wear resistance and reduces dusting. Epoxy and polyurea coatings can be applied later by specialty contractors over our properly prepared slabs.